Peavey CS 1000X Instrukcja Użytkownika

signal levels beyond this point will not produce any significant increase in output and may cause distortionproblems.MODES OF OPERATION1. STEREO MODE

TRANSFORMER/PL-2 MODULE)3 POSITIVESENSITIVITYSENSITIVITYTRANSFORMER(PL-7 MODULE)2 NEGATIVEX-OVER3 POSITIVE0PATCH PANEL (STEREO MODE) WITH BAL. INPUT T

each crossover having a balanced input (1 l), dual (parallel) unbalanced inputs (13), an unbalanced lowoutput (15), and an unbalanced high output (16)

associated loudspeaker components. To help prevent this, whenever the bridge mode is selected, the standby(“0”) LED and the LED array itself on Channe

Often studio engineers feel the need to defeat the DDT compressor, for fear it might color the sound instudio listening. The DDT compressor is only ac

The term headroom deserves some consideration. Program material (music or speech) is made up of manydifferent frequencies and their harmonics. Most mu

5.unbalanced), the crossover input jacks (13) can be used to patch out full-range signals to otheramplifier/speaker systems that are operating in full

3.4.5.shorted across itself. Remember, just as in the stereo mode, the power LED array (Channel A)should reach 100% indication before the DDT system i

CS-1 000X PATCH DIAGRAMSChannel ASpeakersChannel A (ShIelded)Channel ASpeakersStereo ModeChannel B (ShIelded)PATCH DIAGRAM 1Stereo OperationUnbalanced

THIS LIMITED WARRANTY VALID ONLY WHEN PURCHASED AND REGISTERED IN THE UNITED STATES OR CANADA. ALL EXPORTED PRODUCTSARE SUBJECT TO WARRANTY AND SERVIC

AIntended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosurethat may be of sufficient magnitude to co

IMPORTANT SAFETY INSTRUCTIONSWARNING: When using electric products. basic cautions should always be followed, including the following.I. Read all safe

AWARNING!For optimum performance and reliability DO NOT PRESENT THE AMPLIFIER WITH A SPEAKER LOAD OF LESS THAN 2 OHMS, OR ACOMBINATION OF SPEAKERS THA

DDTTM ACTIVE LEDs (1)The DDTTM active LEDs indicate when compression is taking place. As long as gain reduction is occurring,the LED will continue to

conditions. Next to each ladder the calibration is “dB below full power.” This is a convenient scale thatindicates the amount of power amp headroom le

Never break off the ground pin on the CS 1000X or any amplifier. The use of extension cords should beavoided, but if essential, always use a three-wir

LOW-Z INPUTS (11)Conventional three-pin, female XLR input jacks are provided, which can be used as either the channelinputs or the crossover inputs, d

SPEAKER OUTPUTS (18) (19)Two l/4” jacks and 5-way binding post speaker output terminals are provided for each channel, with all theoutputs from each c

PORTABLE RACK-MOUNT APPLICATIONSDue to the weight of the CS 1000X, we highly recommend that some additional support be provided at theback panel of th