Peavey IRM 8150 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Miksery audio Peavey IRM 8150. Peavey IRM 8150 User's Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 16
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
1
IRM 8150
Powered Mixer
Przeglądanie stron 0
1 2 3 4 5 6 ... 15 16

Podsumowanie treści

Strona 1 - IRM 8150

1IRM 8150Powered Mixer

Strona 2

10XFMR 4 Ω GND LO HIBalanced(600Ω)4 Ω–+Direct Output to 4Ω SpeakerTransformer Output to 8Ω Speaker(Note: Jumper must be in place.)COM 8 Ω 25V 70V NC8

Strona 3

11XFMR 4 Ω GND LO HIBalanced(600Ω)8 Ω–+Direct Output to Multiple Speakers in Parallel.Total Impedance = 4Ω8 Ω–+

Strona 5

13CHANNEL INPUTMAX (1/4")(+ 26 dBV)CHANNEL INPUTMINIMUM (1/4")(-20 dBV)CHANNEL INPUTNOMINAL (1/4")(0 dBV)CHANNEL INPUTMINIMUM (XLR)(GAI

Strona 6

14LIMITED WARRANTY Peavey Electronics Corporation warrants to the original purchaser of this new Architectural Acoustics product that it is free f

Strona 7 - BLOCK DIAGRAM

15IMPORTANT SAFETY INSTRUCTIONSWARNING: When using electric products, basic cautions should always be followed, including the following.1. Read all sa

Strona 8 - SPECIFICATIONS

16Features and specifications subject to change without notice.A Division of Peavey Electronics Corporation711 A Street / Meridian, MS 39302-2898 / U.

Strona 9

2Thank you for purchasing the Peavey IRM™ 8150 mixer amplifier. This is an eight-channel,easy-to-use, powered mixer.Your IRM™ 8150 features a rugged,

Strona 10 - Direct Output to 4Ω Speaker

3CHANNEL SECTION:LEVEL (1)Controls the channel output level. This signal is routed via the main bus to the main level control. The channellevel also a

Strona 11 - Total Impedance = 4Ω

4AUX SEND (6)Controls the channel AUX drive level. This signal is routed to the AUX master control, where AUX send signalsfrom all channels are summed

Strona 12

5TAPE/AUX TO MON (14)Controls the level of tape or AUX IN signal to be sent to the mon. bus. This signal will be mixed with channelmonitor signals.TAP

Strona 13 - 8150 LEVEL CHART

6LINE INPUT JACK (18)For use with line level signal or compatible high Z microphones equipped with a 1/4" phone plug.NOTE: These input jacks (17

Strona 14 - LIMITED WARRANTY

7VENT VOIDING THE WARRANTY. If the amp repeatedly blows fuses, it should be taken to a qualifiedservice center for repair.WARNING: THE FUSE SHOULD ONL

Strona 15 - SAVE THESE INSTRUCTIONS!

8SPECIFICATIONSNOTE: All specifications are typical unlessotherwise noted.0 dBV = 1 volt RMS0 dBu = .778 volts RMSAll specs are referenced to nominal

Strona 16 - ARCHITECTURAL ACOUSTICS

9Output Impedance:100 ohmsMASTERGain:Main: = 20 dBMonitor: = 15 dBTape: = 15 dBAux: = 15 dBMaximum Output Level:Main: = +18 dBV (8.0 V RMS)Monitor: =

Komentarze do niniejszej Instrukcji

Brak uwag